Exports of Solar Water Heaters - Megasun Solar Energy Systems Manufacturer and Exporter in Europe (Greece) |
| 5. INSTALLATION INSTRUCTIONS OF THE STORAGE TANK AND COLLECTOR ON THE SUPPORT BASE |
Before the placement of the collectors on the support base, loosen the screws of the bottom plate E, so that the bottom fin of the collector can pass easy between the plates E and B.
The top plate (E) is fixed after the placement of the collector(s).
Place and centralize the collector(s) on the support base.
For the models 200, 260 and 300, which consist of two collectors, you must connect them to each other by using the pipe unions (12), supplied with each appliance. |
 |
Secure the bottom part of the collector(s) by screwing tightly the bottom plate E on the plates B.
|
click on grey-outlined area to zoom in |
Screw tightly the top plate E, on the plates B, securing the collector(s).
|
 |
Place the face plate (20A) on the U, and secure it under the collector(s).
|
click on grey-outlined area to zoom in |
Then place the storage tank on the two U.
Attention:
a. Before placing the storage tank on the two U, check carefully if the plates U and Z are screwed tightly to the plates B.
b. The electric resistance must be on the right hand side, as we face the appliance. |
 |
|
c. Ensure that the appliance does not tilt from one or the other side and that the tubes (02) and (14) of the storage tank are vertical on the highest point of the storage tank. Use necessarily a plumb. |
 |
